There is no need to plug or cover floor drains with the Petro-Plug® oil floor drain strainer you are always protected. Petro Plug floor oil drain plug is designed to fit into industrial floor drains, basement floor drains and garage floor drains, allowing water to drain while filtering out oil sheen.

In the event of an oil spill, the Petro-Plug® oil floor drain strainer goes to work. It's patented filter material absorbs hydrocarbons on contact shutting off any flow into sewer lines, sump pits, oil/water separators, catch basins and more. Spills can now be cleaned at the source, providing significant savings in oil spill clean up with these oil plugs.

Petro-Plug floor drain oil plugs are constructed of rigid PVC for strength and durability. These floor drain oil plugs are easy to install by simply removing the drain grate and slipping the Petro Plug® into the drain pipe.

This powerful oil drain plug protects industrial floor drains from:
Gasoline, Deisel, #4 Oil, Crude Oils, Transformer Oil, Motor oil, Hydraulic oil, lubricating oils, Jet A Fuel, Cable Oil, Kerosene and PCB's.

Installs In Seconds:
Simply remove drain grate and insert Petro Plug into oil drain plug.

Petro-Plug® floor drain plugs are patented that use unique “filters” to protect small floor drains in garages, basements, maintenance pits and underground transformer vaults.  

These floor drain oil plugs are designed to work in standard piped floor drains, stopping grease and oil while allowing water to flow through the basement floor drain as usual.  It's  patented oil stopping filter material  will remove any grease or oil that would have otherwise gone down the basement, garage and industrial floor drains along with the water. Uncontaiminated water will drain at approximately 5 quarts per minute with standard sized floor drains.

The Petro-Plug  floor drain plug protects your industrial floor drains for a full year acting just like a barrier. If a spill of oil runs to the floor drain, the Petro-Plug  forms a plug to prevent any leakage of oil into the drain plug.  Oil cannot get through the Petro Plug floor drain plug.

Petro-Plug® floor drain plugs are made to be quick and easy to install. These oil floor drain strainers are a disposable oil barrier that is more effective and less expensive than an oil/water separator.  The 3-inch Petro-Plug floor drain plug has been designed to simply slide into a standard 3-inch pipe drain, likewise a 4-inch Petro Plug®  oil floor drain plug will easily slip into a 4-inch diameter pipe drain.  When installed in vertical drains have a flow rate from one quart to three gallons per minute depending on the diameter of the Petro-Plug®.

For areas with a high water table, or specifically for underground transformer vaults, the Underground Vault Petro-Plug  has a check valve that can keep ground water from coming up into the Petro-Plug® from below.  Indoor automotive repair garage drains, covered floor areas where oils are stored, or anywhere small amounts of water must be sent to a drain with the risk of oil contamination is ideal for the installation of a Petro-Plug®